Description

Specifications

•Shell: 1/4" PL, Round bottom, 70" radius floor support: 10" channel longitudinal runners (4) with 8" channel and formed 1/4" PL channel crossmembers, 2" x 4" vertical outside support tubes
•Walls: 1/4" PL solid welded, smooth inside, with formed channel supports outside
•Roof: Flat top, 1/4" PL solid welded with channel supports outside
•Front/Rear: 1/4” PL solid welded, smooth inside, with formed channel supports outside
•Drain/Fill: 4" drain at floor each end, 4" connection on front, 4" connection on roof
•Manway: 21" manway on front, side, (2) 36" manway of roof
•Pick up: Standard 5th wheel King Pin
•Welds: All welds continuous except
•Substructure crossmembers axle: 25,000 lb axle with air brakes, 11.00 x 22.5 radial tires on steel disc wheels
•Mixer: (4) 10 HP mixer with gearbox, electric motor, 40" dia. bottom impeller, 20" mid lever impeller, 4 blades per impeller controls: Front mounded service disconnect for power connection, top mounted motor control center for each motor with power light, motor run light, starts, stop, each motor equipped with circuit breaker and overload heater protection, on roof, fold down handrail system
•Finish: Interior steel grit blasted and lined with 100% solids epoxy chemical resistant tank lining, exterior steel grit blasted and color coated with rust inhibiting polyurethane
•Hydrotesting: Full capacity static test
•Dimensions:
46' length,
8'-6' wide,
11' high,
400 BBL capacity
•Accessories: Pressure/Vacuum relief vent

Product Images

Product PDFs

 K8c-400-BBL-Mixing-tank.pdf